2005 Honda CR-V: Evo-one will not program.
I completed the flash link with the evo-one and everything is said to be correct. I'm using for both bypass and remote start from factory key. I installed wiring based on the online manual for the 05 crv following connection #2.
main 6 pin harness:
red to 12v (white)
yellow to starter (black/white)
Pink to ignition (black/yellow) with the added yellow wire from ignition A plug
black is grounded
orange accessory to accessory (black/red)
white to blue parking lights
A plug: yellow to pink ignition, light blue data to white wire on pin two of cylinder harness, and foot brake wire to foot brake (white/black) right above the brake pedal.
D plug: the five pin at the key cylinder (blue/orange) was cut. The white green was attached at the key side and white red attached toward hood side as shown.
I have power to the evo-one and following the manual to enter program mode by pressing and holding down program button and plugging in power I get the lights going through the flashing sequence, however I do not get the solid red. Am I doing something wrong here or not waiting long enough? Is wiring right? All wiring is soldered connections. I appreciate any help.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
